Power Source Connection - Pace DUAL THERMOPIK DTP-80 Operation & Maintenance Manual

POWER SOURCE CONNECTION

If using your DTP-80 ThermoPik for the first time or if you have just
replaced the heater, you must follow the "DTP-80 Heater Burn-in"
procedure (red tag on handpiece) to increase the life expectancy of the
heater and to minimize any smoke and fumes generated by the heater on
its initial power-up.
Connect the handpiece power cable connector to one of the front panel power
receptacles on your PACE power source. PACE recommends that air handpieces
utilize the power receptacles closest to the AUTO SNAP-VAC (or SNAP-VAC) Port
to minimize cord tangles.
To insure optimum performance, use only one Dual ThermoPik
handpiece and any other SensaTemp handpiece (except TT-65
ThermoTweez) on 2 channel power sources. On MBT 250A/220A or
PRC 2000 systems, use of 2 Dual ThermoPiks or a Dual ThermoPik
and a ThermoTweez handpiece may be powered by the same power
source with the third channel left vacant (no handpiece connected).
6
NOTE
NOTE