Table of Contents
Advertisement
VACUUM CUP INSTALLATION/REMOVAL
Three vacuum cup sizes are available for use with the DTP-80 handpiece. For
optimum performance, select the largest vacuum cup which is smaller than the body
of the component being removed. Use the supplied Tip & Vacuum Cup Tool and the
following instructions to remove or install the vacuum cup.
Do NOT install or remove a Vacuum Cup with bare hands! Always use
the Tip & Vacuum Cup Tool! Installation by any other means may cause
burns to the operator.
INSTALLATION
1. Ensure that the proper tip is installed in the
handpiece.
2. Place the selected Vacuum Cup on the Pin of
the Tip & Vacuum Cup Tool as shown.
3. Press the vacuum hose against the
handpiece handle as shown. This will
hold the Vacuum Pick in position.
12
WARNING
Advertisement
Table of Contents
