Toyota Hiace Owner's Manual page 79

Preset buttons
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station (see "TUNE·SEEK").
Push and hold down the button until you
hear a beep—this will set the station to
the button. The button location will appear
on the display.
To tune in to a preset station: Push the
button for the station you want. The but-
ton location, and station frequency will ap-
pear on the display.
These systems can store one AM station
for each button. The preset
memory will be canceled out if the power
source is interrupted (battery disconnected
or fuse blown).
PWR·VOL (Power·Volume)
Push "PWR·VOL" to turn the audio system
on and off. Turn the "PWR·VOL" to adjust
the volume.
TONE
Turn the "TONE" knob to adjust the tone.
72
TUNE·SEEK
Tuning
Push and release the "
(down) side of "TUNE·SEEK" to step up
or down the station band. If you hear a
beep, you held the button too long and
the radio will go into the seek mode.
Seeking
In the seek mode, the radio finds and
plays the next station up or down the
station band.
To seek a station, push and hold the "
or " " side of "TUNE·SEEK" until you
station
hear a beep. Do this again to find another
station.
" (up) or " "
"