Replacing Light Bulbs - Toyota Hiace Owner's Manual

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
To prevent burning yourself, do not
D
replace the light bulbs while they
are hot.
Halogen bulbs have pressurized gas
D
inside and require special handling.
They can burst or
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light,
Toyota dealer.
shatter if
Light Bulbs
Headlights
Front fog lights
Parking lights
Front turn signal lights
Side turn signal lights
Rear turn signal lights
contact your
Stop/tail lights
Back−up lights
High mounted stoplight
License plate lights
Front interior light
Rear interior lights
Step light
Door courtesy lights
A: H4 halogen bulbs
B: H3 halogen bulbs
C: Single end bulbs
D: Wedge base bulbs
E: Double end bulbs
W Type
60/55 A
55 B
5 D
21 C
5 D
21 C
21/5 C
21 C
21 C
5 D
10 E
10 E
5 E
3 E
175