Canon DR-5060F Instructions Manual page 59

Count Only mode setting (See "Count Only key lit: Count Only mode" P. 41)
Sets use of the imprinter/endorser in the Count Only mode.
U8-0: Do not use imprinter/endorser in Count Only mode. (default)
U8-1: Use imprinter/endorser in Count Only mode.
Endorser stamp mode setting
Sets the endorser mode.
U9-0: Use the endorser in the check mode. (default)
U9-1: Use the endorser in the A4/LTR mode.
Space feed setting
Sets the space feed amount. Set in 5 mm (0.2 in.) increments within the range
5 mm to 1500 mm (0.2 in. to 58.5 in.).
U11– –: (default: 10 mm (0.39 in.))
Leader feed setting
Sets the leader film feed amount. Set in 100 mm (3.9 in.) increments within the
range 500 mm to 3000 mm (19.5 x 117 in.).
U12– –: (default: 1500 mm (58.5 in.))
Trailer setting
Sets the trailer film feed amount. Set in 100 mm (3.9 in.) increments within the
range 500 mm to 3000 mm (19.5 x 117 in.).
U13– –: (default: 1500 mm (58.5 in.))
Film end detection amount setting
Sets the film end detection amount. Set in 100 mm (3.9 in.) increments within
the range 1500 mm to 3000 mm (58.5 in. to 81.9 in.).
U14– –: (default: 1500 mm (58.5 in.))
MEMO
The setting value for the film end detection amount is for when Canon CK III
film (5 mm (0.2 in.) thick) is used. Double this setting value when 2.5 mm (0.1
in.) film is used.
Backup mode setting
Sets use of the Scanner Only mode.
U15-0: Scanner Only mode disabled
U15-1: Scanner Only mode enabled (default)
MEMO
Setup items U5 to U9 are available only when the corresponding optional
device is attached.
For setup items U11 to U14, "-" is displayed at the end of the setting value.
(See "How to Set the User mode" P. 58)
Setting Scan Conditions
3
57