Canon DR-5060F Instructions Manual page 57

Imprinter
When the optional imprinter is installed on the scanner, you can select whether
or not to use the imprinter by function key.
To enable use of the imprinter, press the function key to which the imprinter is
registered, and scan the document with the key lamp lit.
To disable use of the imprinter, scan the document with the key lamp off.
Film Density
Select the photographic density of the film within the range -3 to +3, and
register it to a function key. Normally, "0" is set as the film density.
MEMO
The density must sometimes be adjusted according to the film or developer you
are using. For details, contact a Canon service department.
Odometer Indication
If you press the function key to which odometer indication is registered, the
3
function key lamp lights, and the counter display indicates "-odo-". This display
then changes to indicate the odometer level of the currently loaded camera
unit. The odometer level is indicated within the range 00000 to 65535, and the
odometer level numerical value is held in DR-5060F memory even if the
camera unit is replaced or the main unit is turned OFF. To reset the odometer
indication, hold down the Clear/Stop function key for about two seconds with
the odometer level displayed.
Page Address Indication
If you press the function key to which page address indication is registered, the
function key lamp blinks, and the counter display indicates "-P-". This display
then changes to indicate the page address of the currently loaded camera unit.
The page address is indicated within the range 00000 to 99999, and the page
address numerical value is held in DR-5060F memory even if the camera unit
is replaced or the main unit is turned OFF. To clear the page address indication,
hold down the Clear/Stop function key for about two seconds with the page
address displayed. The file address is also cleared by this operation.
File Address Indication
If you press the function key to which file address indication is registered, the
function key lamp blinks, and the counter display indicates "-F-". This display
then changes to indicate the file address of the currently loaded camera unit.
The file address is indicated within the range 00000 to 99999, and the file
address numerical value is held in DR-5060F memory even if the camera unit
is replaced or the main unit is turned OFF. To clear the file address indication,
hold down the Clear/Stop function key for about two seconds with the file
address displayed. The page address is also cleared by this operation.
Restore Memorized Setting
Different settings can be registered to each of the function keys, so that you
can store settings matched to specific originals.
To use registered scanner settings, press the key to which the desired scanner
settings are registered, and the document with the key lamp lit.
55
Setting Scan Conditions