Manual Thickness Adjustment - Canon DR-5060F Instructions Manual

Manual Thickness Adjustment

This scanner is initially set to automatically detect the thickness of paper during
scanning. This function, however, may not function properly when scanning
extremely thick or thin paper. If this happens, the user must manually adjust the
paper thickness so that documents are fed smoothly through the scanner.
The procedure for manually adjusting the paper thickness is as follows:
1
Press the function key to which Manual Thickness Adjustment is
registered (default is function key 1).
The function key blinks, and "Adj" appears blinking on the counter display. The
Semi-Auto lamp at Feeding Option lights, and the Start key blinks green.
Scanner
A
MEMO
To cancel the manual paper thickness adjustment function, press the blinking
key or the Stop key.
2
Load one sheet from the document to be scanned on the
document tray, and press the Start key.
This scans the document, and the paper thickness is displayed on the brightness
indicator.
MEMO
The paper thickness displayed on the indicator does not represent the exact
paper thickness, but serves as an aid when adjusting the paper thickness.
3
Press the or
Pressing the or
To set a thicker paper setting, press the
the key. The paper thickness can be adjusted in 13 steps.
4
Press the blinking function key again.
This sets the paper thickness, and resets the counter display.
MEMO
To enable the value set in the above procedure, you must set Fixed
Thickness Mode (See "Fixed Thickness Mode" P. 54).
The paper thickness can also be adjusted by the application. When the
paper thickness has been adjusted on both the scanner operation panel and
in the application, priority is given to the last made setting.
key to adjust the paper thickness.
key moves the indicator display to the left and right, respectively.
key. To set a thinner paper setting, press
Setting Scan Conditions
3
53