Yanmar 2V Series Operation Manual page 27

A
CAUTION
FLYING OBJECT HAZARD!
• ALWAYS wear eye protection when
servicing the engine and when using
compressed air or high-pressure
water. Dust, flying debris, compressed
air, pressurized water, or steam may
injure your eyes.
• Failure to comply may result in minor
or moderate injury.
CAUTION
• Only use diesel fuels recommended by
Yanmar for the best engine
performance, to prevent engine
damage and to comply with EPA / ARB
warranty requirements.
• Only use clean diesel fuel.
• NEVER remove the primary strainer (if
equipped) from the fuel tank filler port.
If removed, dirt and debris could get
into the fuel system causing it to clog.
CAUTION
NEVER attempt to adjust the low or high
idle speed limit screw. This may impair
the safety and performance of the
machine and shorten its life. If
adjustment is ever required, contact
your authorized Yanmar industrial
engine dealer or distributor.
2V Operation Manual
• NEVER remove or attempt to remove
the tamper-proof devices from the full-
load fuel adjusting screw or the high-
speed throttle limit screw on the fuel
injection pump and governor
assembly. These adjustments have
been made at the factory to meet all
applicable emissions regulations and
then sealed.
• NEVER attempt to make any
adjustments to these sealed
adjustment screws. If adjustments are
required, they can be made only by a
qualified fuel injection shop that will
ensure the injection pump continues
to meet all applicable emissions
regulations and then replace the
0000003en
tamper-proof seals.
• Tampering with or removing these
devices may void the "Yanmar Limited
Warranty."
If any problem is noted during the visual
check, the necessary corrective action
should be taken before you operate the
engine.
0000004en
NEVER hold the key in the START
position for longer than 15 seconds or
the starter motor will overheat.
0000045en
SAFETY
CAUTION
0000146en
CAUTION
0000021en
CAUTION
0000007en
11