Advertisement
ASSEMBLY OF THE FLOW REGULATOR OF THE MIX-LIFE SYSTEM)
11
12
11
17
2a)
Lubricate with Vaseline the whole for the regulators on block 11
2b)
Assemble and lubricate with Vaseline the o-rings 17 on body 7
2c)
Turn the regulator off by turning it counter-clockwise
2d)
Insert body 7 on its whole in block 11.
2e)
Tighten washer 8, with the proper tool
2f)
Assemble and lubricate with Vaseline the o-rings 12 on body 4
2g)
Turn the regulator off by turning it -clockwise).
2h)
Insert body 4 on its whole in block 11
2i)
Remove knob 1 which was assembled previously ( see 1.b).
2l)
Insert washer 14 on rod 2 and turn it with the proper tool
2m)
Screw the bolt 15 , leaving about 1mm±0.2mm. between grill 14 and bolt 15.
2n)
-screw the gear 16 up to bolt 15, and tighten without the use of tools, making sure that bolt 15 is
fixed at 1mm from washer 14.
2o)
Insert gear 18 onto flange 18 and screw without tightening the screw (screw TCEI zinc. M3x6) with
its washer 19 (flat washer M3).
2p)
Insert between the teeth of the gears ( from the upper side) a piece of soft PVC in order to block the
reciprocal rotation, therefore tighten with the proper tool the bolt 15 without excessive force.
2q)
Remove the piece of PVC and verify that the rotation of the regulators is regular and without
interference.
2r)
Lubricate the gears with a little bit of Vaseline.
P.N.: DU5506130
.ﻣراﺟﻌﮫ ﻓرﻣﺎﯾﯾدWWW.ELM-FAN.IRﺑرای داﻧﻠود ﻣوارد ﺑﯾﺷﺗر ﺑﮫ ﺳﺎﯾت
AM5000 – AM5000/3 – AM5000/5
14
4
7
8
9
Page 15 of 34
To download more items, go to ELM-FAN.IR
Service Manual
REGOLATORE DEL
PROTOSSIDO DI AZOTO
1mm
2
15
16
REGOLATORE DEL
25% OSSIGENO
25% OXYGEN
REGULATOR
20
19
18
NITROUS OXIDE
REGULATOR
Rev.: 3.0
Advertisement
