Maintenance - Bosch Autodome Inteox 7000i-2MP Installation Manual

38 en | Maintenance
12

Maintenance

All bubbles require special care when handling and cleaning to avoid scratches.
Notice!
i
To avoid excessive moisture saturation inside the housing, limit the amount of time that the
bubble is disconnected from the housing. Bosch recommends that the bubble be removed
from the housing for no more than five (5) minutes.
Bubble Handling
The bubble may be packaged with a protective plastic sheet. It is recommended that the
bubble remain stored this way until it is ready to install. Limit handling the bubble, as any
scratches can quickly affect visibility.
Bubble Cleaning
If cleaning the bubble is required, use the following procedures and comply with all the
warnings listed below.
Cleaning the Bubble Interior
The extremely soft interior surface should not be cleaned by rubbing or dusting with a cloth.
Use clean dry compressed air, preferably from a spray can, to remove any dust from the
interior surface.
Warning!
Do not use alcohol-based solutions to clean the bubble. This will cause the surface to cloud
!
and, over time, cause stress aging, which makes the bubble brittle.
Cleaning the Bubble Exterior
The exterior of the bubble is hard-coated for extra protection. If cleaning becomes necessary,
only use cleaning solutions and cloths suitable for cleaning safety glass lenses. Dry the bubble
thoroughly with a dry nonabrasive cloth to prevent water spots. Never scrub the bubble with
any abrasive material or cleaners.
Bosch recommends cleaning the exterior of the bubble with NOVUS "No. 1" Plastic Clean &
Shine (or equivalent), according to manufacturer's instructions. Refer to
www.novuspolish.com
Cautions
–
–
–
–
Remove an SD card
1.
2.
3.
4.
2021-08 | 1.4 |
to order or to find a local distributor.
Do not clean bubbles in the hot sun or on very hot days.
Do not use abrasive or highly alkaline cleaners on the bubble.
Do not scrape the bubble with razor blades or other sharp instruments.
Do not use Benzene, Gasoline, Acetone, or Carbon Tetrachloride on the bubble.
Follow the steps in one of these sections (depending on the type of camera mount):
Remove the bubble from an in-ceiling housing, page 14 or Remove bubble from a pendant
housing.
Press down the end of the SD card until it ejects partially from the connector.
Pull out the SD card and put it in a safe location.
Follow the steps in one of these sections (depending on the type of camera mount):
Replace the bubble in an in-ceiling housing or Replace the bubble in a pendant housing.
Installation Manual
AUTODOME inteox 7000i - 2MP (in-ceiling)
Bosch Security Systems