Replacing The Trim Ring And Bubble - Bosch Autodome Inteox 7000i-2MP Installation Manual

AUTODOME inteox 7000i - 2MP (in-ceiling)
6

Replacing the trim ring and bubble

Replace the trim ring (optional) (In-ceiling models)
The dome bubble for in-ceiling models of AUTODOME 7000 comes assembled with a white
trim ring. An optional black trim ring is supplied in the shipping box. To replace the white trim
ring, follow these steps:
1.
2.
3.
4.
5.
Replace the bubble in an in-ceiling housing
Figure 6.1: In-Ceiling Bubble
1.
2.
3.
Warning!
Trim ring can become deformed
If the trim ring is not turned completely, the screw slot on the trim ring will not be aligned
!
with the screw slot in the housing. You cannot see the screw slot in the housing when you are
turning the screw in the slot in the trim ring. You can turn the screw in the slot in the trim
ring, but miss the screw slot on the housing. Forcing the screw into the trim ring (without the
screw going into the screw slot in the housing) can deform the ring.
4.
Bosch Security Systems
Remove the four (4) Phillips head screws from the inner ring.
Remove the white trim ring.
For in-ceiling models, verify that the trim ring gasket is in place. (Refer to the graphic in
Installing the Ceiling (IP54 Housing) Gasket, page 19 for an illustration of the correct
placement of the gasket.)
Place the black trim ring over the inner ring.
Replace and tighten the four (4) screws.
Use a non-permanent marking instrument (such as chalk or a carpenter pencil) to mark on
the ceiling the screw slot in the in-ceiling housing.
Place the bubble over the camera module, and align it until it settles.
Rotate the trim ring, not the bubble itself, clockwise until it locks in position in the
housing. The ring becomes tight and may be difficult to turn. Aligning the screw slots by
using the chalk or pencil mark as reference ensures that you align both screw slots.
Erase the chalk or pencil mark if desired.
Installation Manual
Replacing the trim ring and bubble | en 17
2021-08 | 1.4 |