Unpacking The Instrument; Multimeter Safety - Fluke 27/FM Operator's Manual

Multimeter Safety
divider provides a high input impedance. Before using the 80K-6 probe, read
the instruction sheet that accompanies it.
UNPACKING THE INSTRUMENT
The meter is shipped with a 80K-6 high voltage probe (and instruction
sheet), TL70 test leads, two alligator clips (one red and one black), a 9V
alkaline battery, this operator's manual, and a protective carrying case for
meter and accessories. Contact the place of purchase immediately if anything ,
is missing or damaged.
When reshipping the meter, use the original container. If this container is
not available, we recommend that the instrument be surrounded by at least
three inches of shock-absorbing material in the shipping container.
MULTIMETER SAFETY
Before using the meter, read the following safety information carefully. In
this manual, the word "WARNING" is reserved for conditions and actions
that pose possible hazard(s) to the operator; the word "CAUTION" means
damage to the meter may occur. The symbols shown in Figure 1 are used
internationally to denote the electrical functions and conditions indicated.
o Avoid working alone.
o
Inspect the test leads for damaged insulation or exposed metal.
Check test lead continuity. Damaged leads should be replaced.
o Be sure the DMM is in good operating condition. During the
continuity test, a meter reading that goes from OL (overload) to 0
normally means the meter is working properly.
o
Select the proper function and range for your measurement.
o A 101
When servicing, use only specified replacement parts.
OFF Ipower)
SWITCH
POSITION
VOLTAGE
DANGEROUS
I
ON Ipower)
SWITCH
POSITION
-I- — _ GROUND
."-N...„..
AC-
ALTERNATING
CURRENT
A
SEE
EXPLANATION
IN MANUAL
DC-
DIRECT CURRENT
DOUBLE
INSULATION
iProtection Class II)
•
- — —
EITHER
.-41.• FUSE
Figure 1. International Electrical Symbols