Advertisement
CAUTION:
If using a cordless power drill / screwdriver, turn torque setting down to
a minimum level to start so that screws are not stripped. Adjust torque up slightly if
needed to fully tighten screws.
Step 1: Attach the
(2)
using screws (A)*4pcs. Then attach the
panel (4)
using screws (B)*8pcs.
2
L
Step 2: Attach the
Back panel of flower box (7)
and the
Floor panel of flower box (8)
place the
CAUTION: Do not over tighten screws.
E
5
E
7
ASSEMBLY INSTRUCTION
Front&Back run panel (1)
2
1 R
1
Side panel of flower box (5)
6
5
Front&Back short run panel
and the
Left run panel (3)
3
Front panel of flower box (6)
, the
using screws(E)*12pcs as shown. And then
into the box.
Right run
and the
4
Advertisement
