Advertisement
Step 13: Locate both Roof panels (23) and position them on the ground with wooden
frame side up as seen in the picture below. Next place the wooden Support bars (24)
in place on the wooden frames (see picture below) and secure in place with 3 screws
each (E).
***NOTE: The orientation of the wooden support bar before screwing in place. The
Angle cut should be facing the end of the panel with the long end of the angle on top
as noted in picture. This allows the roof panel to be "self-centered" when placed on top
of coop.
Next, lift roof panels and place them in position on top of the coop, then secure in
place with 8 screws (C).
***Please note the right place of the support bar as shown. You shall leave 3.8 inches
from the side.
B
B
23
x2
24
B
B
wooden support bar orientation reference
23
C
C
C
C
C
C
23
Advertisement
