Cleaning, Care And Maintenance; Troubleshooting - Polar Electro G Series Instruction Manual

Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.
• A POLAR agent or qualified technician must carry out repairs if required.
Marble Care
• Do not use abrasive materials or detergents to clean the worktop. Wash with warm, soapy water.
• Dry thoroughly with a soft cloth after cleaning.
• Wipe up any spillages as quickly as possible, particularly liquids such as lemon juice or vinegar.
• POLAR recommend the use of a chopping board to reduce the risk of damage to your worktop.
Cleaning the Condenser Filter
• The condenser is part of the refrigeration system. The
condenser filter requires monthly cleaning.
• Always disconnect power supply before carrying out
Routine Maintenance.
• Failure to clean the condenser filter will reduce the
performance and life of your Polar unit and may
invalidate your warranty.
• These models have a removable filter which can be
cleaned with a vacuum cleaner.

Troubleshooting

If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline or your POLAR dealer.
Fault
The appliance is not
working
GH266 (FT286 & FT287)_GH267 (FT288 & FT289)_ML_A5_v1_20210622.indb 7 GH266 (FT286 & FT287)_GH267 (FT288 & FT289)_ML_A5_v1_20210622.indb 7
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Power supply
Solution
Check the unit is plugged in correctly and
switched on
Call POLAR agent or qualified Technician
Replace the fuse
Check power supply
UK
7
2021/6/22 15:43 2021/6/22 15:43