Installation; Operation; Cleaning, Care And Maintenance - Polar Electro CM287 Instruction Manual

EN

Installation

Not for use in vans or trailers, food trucks
or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
To avoid higher energy consumption and a shorter
compressor life, your refrigerated equipment
should never be installed:
• Near sources of heat such as radiators, direct
or indirect sunlight or other equipment which
produce heat.
• In line with draughts coming from doors,
windows or air-conditioning systems.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water then dry well.

Operation

Control Panel
Refrigerant LED
A
A - Power Switch
B - Controller
4
CM287_ML_A5_v6_20230920.indb 4 CM287_ML_A5_v6_20230920.indb 4
Defrost LED
B
Turn On
1. Ensure the power switch A is set to [O] and
turn on at the socket.
2. Switch on the Power [I]. The current
temperature within the appliance is displayed.
Setting the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the or buttons to display the
required temperature.
3. Press the SET button to store the temperature.
Internal Light
Press the button on the controller to turn the
internal light on and off.
Manual Defrost
Press and hold the button for 6 seconds to
begin or stop a manual defrost. The defrost light
illuminates.
Cleaning, Care &
Maintenance
• Switch off and disconnect from the power
supply before cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Always wipe dry after cleaning.
Condensation and ice will form with frequent
and prolonged opening of the doors.
Operating outside of the recommend
temperature range and placing next to a
heat source will also increase the amount
of ice and internal/external condensation.
If external condensation occurs wipe the
surface down with a cloth.
Excessive ice will result in longer running
times that will increase energy consumption
and increase the deterioration of
components.
This unit is fitted with a condensate heater,
however if ambient humidity rises above
75%, it may be necessary to direct the
drain line (located at the rear) to a suitable
drain outlet or tray.
2023/9/20 17:19 2023/9/20 17:19