Pack Contents; Installation - Polar Electro G Series Instruction Manual

UK

Pack Contents

The following is included:
• POLAR Refrigerator
• Shelf guides
• Shelves
• Gastranorm spacer bar
• Floor guards
• Instruction manual
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.

Installation

Note: If the unit has not been stored or moved in an upright position, let it stand
upright for approximately 12 hours before operation. If in doubt allow to stand.
1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are
thoroughly removed from all surfaces.
2. To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between
the unit and walls and other objects, with a minimum 5cm clearance on the top. NEVER LOCATE
NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the first time, clean the shelves and interior
with soapy water.
3. Level the appliance by adjusting the screw feet.
Fitting the Shelves & Floor Guards
1. Place one set of shelf guides on either side of the cabinet at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
4. Place the floor guards on the floor of the cabinet, ensuring the flat side is clear of the floor.
Note: This is vital for ensuring correct drainage of condensation.
4
GH266 (FT286 & FT287)_GH267 (FT288 & FT289)_ML_A5_v1_20210622.indb 4 GH266 (FT286 & FT287)_GH267 (FT288 & FT289)_ML_A5_v1_20210622.indb 4
• Top glass panel
• Rear glass panel
• Side glass panels x 2
• Collars x 6
• Brackets x 7
• Grub screws x 7
• Screws x 12
• Plugs x 14
2021/6/22 15:43 2021/6/22 15:43