Specifications; Intended Use - Makita TW001G Instruction Manual

SPECIFICATIONS

Model:
Fastening capacities
Square drive
No load speed (RPM)
Impacts per minute
Max. fastening torque
(at max impact mode (4) )
Nut-Busting torque
(at max impact mode (4) )
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
Only for EU countries
Ni-MH
Do not dispose of electric equipment or
Li-ion
battery pack together with household waste
material!
In observance of the European Directives,
on Waste Electric and Electronic
Equipment and Batteries and Accumulators
and Waste Batteries and Accumulators
and their implementation in accordance
with national laws, electric equipment and
batteries and battery pack(s) that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.
Standard bolt
High tensile bolt
Max impact mode (4)
Hard impact mode (3)
Medium impact mode (2)
Soft impact mode (1)
Max impact mode (4)
Hard impact mode (3)
Medium impact mode (2)
Soft impact mode (1)
Fastening with M30 for 6 seconds
Fastening with M30 for 3 seconds
D.C. 36 V - 40 V max
BL4025 / BL4040

Intended use

The tool is intended for fastening bolts and nuts.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-2:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
2 ENGLISH
TW001G
M12 - M36
M10 - M27
19.0 mm
-1
0 - 1,800 min
-1
0 - 1,400 min
-1
0 - 1,150 min
-1
0 - 950 min
-1
0 - 2,500 min
-1
0 - 2,400 min
-1
0 - 2,200 min
-1
0 - 1,900 min
1,800 N·m
1,500 N·m
2,050 N·m
217 mm
3.9 - 4.2 kg
DC40RA
) : 100 dB(A)
pA
) : 111 dB (A)
WA