Table of Contents
Advertisement
7
equipment. Have a qualified electrician install & service this equipment.
Allow machine to sit for 5 minutes minimum to allow the power capacitors to discharge before working
inside this equipment. Do not touch electrically live parts
The Plasma 31C Plasma Cutters requires a 240V 50/60Hz 1-Phase supply. It requires an 13A
supply. It comes with a mains cable attached.
Connect wires according to national coding.
Brown wire – Live, Blue wire – Neutral
Green/Yellow Wire – Earth (Ground)
Connecting to an Engine Driven Generator
If connecting this Plasma Cutter to an engine driven generator, please ensure
the following
Minimum Generator KVA Output – 5KVA continuous
Generator to be fitted with AVR (automatic voltage
regulation) DO NOT USE ON A GENERATOR WITHOUT
AVR
Connecting to a generator without the above minimum requirements will in-
validate your warranty.
Advertisement
Table of Contents
