Replacing The Filters - Gtech MULTI ATF Series Operating Manual

Replacing the filters

Slide the filter onto the inner shroud.
Removing and cleaning the brush bar / jam or fault
If the brush bar jams during use, the product
will stop and the LEDs will appear red. You will
need to remove and clean the brush bar.
5011_System_UF_manual_aw.indd 11 5011_System_UF_manual_aw.indd 11
Slide the filter and inner shroud into the filter
housing.
10
seconds
The product will not re-start until the red lights
go out. This will take ten seconds.
If the problem persists, follow the
troubleshooting instructions on page 14.
11
18/05/2021 16:45 18/05/2021 16:45