Lamp Replace Counter - Canon LV-7575 User Manual

Be sure to reset the Lamp replacement counter after the lamp assembly is replaced. When the Lamp
replacement counter is reset, the LAMP REPLACE indicator stops lighting.
1
Turn the projector on and press the MENU button to
display the On-Screen Menu. Press the POINT
LEFT/RIGHT buttons to move the red frame pointer to
the SETTING Menu icon
2 Press the POINT UP/DOWN buttons to move the red
frame pointer to Lamp counter and then press the OK
button. The next box appears.
3 Press the POINT UP/DOWN buttons to select Reset
and then press the OK button. The "Lamp replacement
counter reset?" appears. Move the pointer to [Yes] and
then press the OK button.
4
Another confirmation dialog box appears and select
[Yes] to reset the Lamp replacement counter.
NOTE:
• Do not reset the Lamp replacement counter until after the projection lamp is
replaced.
This projector uses a high-pressure lamp which must be handled carefully and properly. Improper
handling may result in accidents, injury, or create a fire hazard.
●
Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no
guarantee of the same lifetime for each lamp. Some lamps may fail or terminate their lifetime in a
shorter period of time than other similar lamps.
●
If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator lights
up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down. (Follow
carefully the instructions in the LAMP REPLACEMENT section of this manual.) Continuous use of the
lamp with the LAMP REPLACE indicator lighted may increase the risk of lamp explosion.
●
Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its
lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in
which the projector and lamp are being used.
IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.
If a lamp explodes, disconnect the projector's AC plug from the AC outlet immediately and open the
window or door for ventilation. Contact an authorized service station for a checkup of the unit and
replacement of the lamp. Additionally, check carefully to ensure that there are no broken shards or pieces
of glass around the projector or coming out from the cooling air circulation holes. Any broken shards
found should be cleaned up carefully. No one should check the inside of the projector except those who
are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to
service the unit by anyone, especially those who are not appropriately trained to do so, may result in an
accident or injury caused by pieces of broken glass.

LAMP REPLACE COUNTER

LAMP HANDLING PRECAUTIONS
Lamp counter
Select Lamp counter and this box
appears. Select [Reset], and the
next box appears.
Select [Yes], and then another
confirmation box appears.
APPENDIX
Select [Yes] again
to reset the lamp
counter.
49