Viessmann VITOGATE 200 Installation And Service Instructions Manual page 25

Parameters in ETS
Any fault on a component of the heating
system can trigger the transmission of a
"Fehlerbyte" error byte to an appropriate
central fault message facility. However,
this requires the fault message to be
actually captured by the Vitotronic con-
trol unit.
The fault code can be linked to a plain
text display via the EIB system and be
displayed.
You can select the transmission inter-
val.
Menu selection
5 s bis 120 min (5 s to
120 min)
nicht zyklisch senden
(do not transmit cycli-
cally)
Note
The shorter the cycle time, the higher the
BUS load (for example, see page 22).
Menu selection
nie senden (Never
transmit)
bei jeder Änderung sen-
den (transmit after every
change)
(cont.)
A list of fault codes can be downloaded
from www.viessmann.de/vito-
gate-200-eib.
Zykluszeit (Cycle time)
Menu for the selection of the transmis-
sion interval to be assigned to the central
fault message error bit.
Explanation
The fault message is transmitted cyclically to the EIB sys-
tem in accordance with the selected interval.
The fault message is either never transmitted to the EIB
system or only in the case of a change.
Max Abweichung (Max deviation)
Menu for the selection of the transmis-
sion interval subject to the setting of the
cycle time.
Explanation
The fault message is never transmitted to the EIB.
The fault message is transmitted to the EIB following any
change.
Commissioning
25