Display And Control Elements - Viessmann VITOGATE 200 Installation And Service Instructions Manual
Communication for heating systems via knx/eib systems
Hide thumbs
Also See for VITOGATE 200:
Table of Contents
Advertisement
Commissioning
Display and control elements
A B
8
LON Service
F
A ON indicator "8" (green)
B Reset button (configuration is
retained)
Vitotronic control unit LON integration
The LON communication module
(accessory) must be plugged into the
Vitotronic control unit.
Viessmann system number and subscriber number
Set LON system number, LON sub-
scriber number and further functions via
code 2.
Vitotronic control unit service
instructions and the following
table.
12
C D
Reset
EIB Prog
E
C Status display for the EIB system
BUS coupler (red)
D EIB programming key
for manual integration of the Vito-
gate 200, type EIB into an existing
EIB system
E LON service key
for manual integration of the Vito-
gate 200, type EIB into an existing
LON system
F LON display during LON subscriber
check (yellow-orange)
Note
The data transfer via the LON system
can take several minutes.
Note
Each number can only be allocated once
within the same LON.
Only one Vitotronic control unit per
system may be programmed as the fault
manager.
Advertisement
Table of Contents
