Viessmann VITOGATE 200 Installation And Service Instructions Manual page 23

Parameters in ETS
Menu selection
nie senden (Never
transmit)
bei jeder Änderung sen-
den (transmit after every
change)
5 % bis 25 % (5 % to
25 %)
Error bit central fault message
Example with ETS3
Any fault on a component of the heating
system can trigger the transmission of a
"Fehlerbit Sammelstörung" error bit cen-
tral fault message to an appropriate cen-
tral fault message facility. However, this
requires the fault message to be actually
captured by the Vitotronic control unit.
You can select the transmission inter-
val.
(cont.)
Explanation
The value of this datapoint is never transmitted to the EIB
system.
The value of this datapoint is transmitted to the EIB system
following any change.
The value of this datapoint is transmitted to the EIB system
in the case of a deviation according to the set percent-
age.
Zykluszeit (Cycle time)
Menu for the selection of the transmis-
sion interval to be assigned to the central
fault message error bit.
Commissioning
23