Viessmann VITOGATE 200 Installation And Service Instructions Manual page 21
Communication for heating systems via knx/eib systems
Hide thumbs
Also See for VITOGATE 200:
Table of Contents
Advertisement
Parameters in ETS
Note
The subscriber number must also be
programmed into the Vitotronic control
unit selected under "Regelung" (for cod-
ing, see page 13).
Vitogate 200, type EIB is factory-set to
subscriber number "98" (delivered con-
dition).
Menu selection
Bedienung A1/M1
(Operation A1/M1)
Bedienung M2 (Opera-
tion M2)
Bedienung M3 (Opera-
tion M3)
Information
Diagnose (Diagnosis)
5. Gruppe
Menu for the selection of a group of data-
points to be assigned to the correspond-
ing communication object.
(cont.)
4. Dienst
Menu for the selection of the function to
be assigned to the corresponding com-
munication object.
Function
Input of the operating parameters for heating circuit A1 or
M1 (e.g. operating modes), subject to the Vitotronic control
unit assigned under "Regelung".
Input of the operating parameters for heating circuit M2
(e.g. operating modes), subject to the Vitotronic control unit
assigned under "Regelung".
Input of the operating parameters for heating circuit M3
(e.g. operating modes), subject to the Vitotronic control unit
assigned under "Regelung".
Service scans for actual values and conditions (tempera-
tures, operating status of pumps), subject to system con-
figuration.
Service scans for set values, actual values and conditions
(temperatures, operating status of pumps), subject to sys-
tem configuration.
Commissioning
21
Advertisement
Table of Contents
