Advertisement
For shipping
purposes,
the
controls of your snow thrower have not been assembled
to the unit. The carton of parts, in which this owner's
manual was found, contains all components
ware necessary to complete
the assembly.
NOTE:
The terms
Left Hand (L.H.) and Right Hand
(R.H). refer to your
left and right
stand in the operator's
position
ATTENTION:
FOR EASIER ASSEMBLY,
THROWER FORWARD SO THAT IT RESTS ON SAFETY
BAR AS SHOWN (FIG. 2).
HANDLE ASSEMBLY
1. Slide
lower
two
holes
of R.H. handle
screws on R.H. side of snow thrower
3). Assemble
formed
washer to upper weld screw,
and
secure
handle
with
Tighten
finger tight only.
2. Assemble
L.H. handle
to snow thrower
manner.
r'
0
~
~.:y
CHASSIS
!
~~~~f*
\ "'"· -J
\
WELD SCREWS
3. Assemble
handle
plate to handles
four 5/16-18 x 1
¥.i
carriage
flange nuts. Tighten
securely.
4. Tighten
four
-16 flange
3fs
lower end of both handles (Fig. 3).
handles
and
operating
and hard-
hands when you
behind the unit.
TILT
SNOW
over weld
chassis (Fig.
two
-16 flange
nuts.
3fs
in same
RIGHT HANDLE
/
FORMED WASHER
~I
rn~
c'
@
FLANGE NUTS
(Fig. 4), using
bolts and four 5/16-18
nuts
securely
against
FIG. 4
SHIFT CONTROL ROD ASSEMBLY
1. Assemble
one
-16 flange nut (A) to end of shift
3fs
control
rod having
the
longest
Flange of nut must face toward
shift control
rod as shown (Fig. 5 and 6). Thread
the nut the full length of the threads.
TRANSMISSION
(C)
'Z' SLOT
HANDLE
PLATE
LOCATING
PIN
SHIFT CONTROL
ROD
SHIFT
CONTROL
ROD________
TRANSMISSION
CONTROL BKT.
TRANSMISSION
SHIFT~~.
~~\
~
/
~
\\.
FIG. 6
2. Position other end of shift control
slot in top of handle plate, so that locating
rod engages the "Z" slot in handle
Swing transmission
control
6), and insert
lower end of shift
hole in transmission
control
3. Assemble one
-16 flange nut (B), with flange up,
3fs
to lower end of shift
control
tighten
nut.
4. IMPORTANT:
Position
transmission
neutral position (Fig. 7), approximately
of slot in rear cover. Rotate wheels of unit; wheels
should turn freely if neutral has been obtained. Shift
lever may have to be moved up or down slightly
from centre of slot in order to obtain neutral.
(Fig. 5 to 8)
threaded
portion.
threaded
end of
CONTROL
BRACKET
A
/
~ .....
~~
rod up through
pin on
plate (Fig. 5).
bracket
upwards
(Fig.
control
rod into
bracket (Fig. 5 and 6).
rod (Fig. 6). Do not
shift
lever in
in the centre
Advertisement
