Advertisement
Engine - Exhaust Gas Recirculation (EGR) - Diesel Particulate Filter (DPF) exhaust treatment
Automatic diesel particulate filter regeneration inhibition DPF
If you want to inhibit or enable automatic regeneration of the diesel particulate filter, proceed as described below:
• Press the switch (2) on the symbol (B) for more than three seconds to enter the programming menu
The central monitor will show "SETUP MENU". Release the symbol (B).
• Press the switch (3) on the symbol (D) a number of consecutive times until the monitor shows the symbol of the
filter S1 .
• Press the switch (2) on the symbol (B) and press the switch (3) on the symbol (D) to display the screen S2 then
press button (B)
• YES = automatic regeneration of the filter INHIBITED
• NO = automatic regeneration of the filter ENABLED
• It is possible to change the setting status by moving with the direction keys of the switch (3) on the symbols (C) and
(D)to pass from "yes" to "no" and vice versa, then confirm by pressing the switch (2) on the symbol (B).
If automatic regeneration is disabled the following warning light on the dashboard remains on steady
and every 5 minutes the central monitor shows the following symbol combined with a single beep.
If the setting in the system matches the needs of the work to perform, press the switch (2) on the symbol (A) a number
of times to exit the programming menu.
NOTICE: It is always advisable to have the automatic regeneration function ENABLED.
6
DCAPLT5NE071S3F
47840679 10/03/2015
10.3 [10.501] / 10
Hide quick links:
Advertisement
