Kubota WSM L4400 Workshop Manual page 29

L4400, WSM
[3] CHECK POINTS OF EVERY 50 HOURS
Adjusting Clutch Pedal Free Play
1. Slightly depress the clutch pedal (5) and measure free travel
on top of clutch pedal.
2. If the measurement is not within the factory specifications,
loosen the lock nut (2), remove the cotter pin (3) and the clevis
pin (4), then adjust the length of rod (1) within acceptable
limits.
3. Retighten the lock nut, reinstall the clevis pin, the cotter pin
and split the cotter pin.
Clutch pedal free
travel on top of clutch Factory spec.
pedal
(1) Clutch Pedal Rod
(2) Lock Nut
(3) Cotter Pin
Greasing
1. Apply a grease to the following position as figures.
Apply a small amount of multipurpose grease to the
following points every 50 hours.
If you operated the machine in extremely wet and muddy
conditions, lubricate grease fittings more often.
When apply a grease to the front axle support, remove the
breather plug and apply a grease until grease overflows
from breather plug. After greasing reinstall the plug.
(1) Grease Fitting
(Knuckle Shaft RH, LH)
(2) Grease Fitting
(Front Axle Support)
G-16
GENERAL
20 to 30 mm
0.8 to 1.2 in.
(4) Clevis Pin
(5) Clutch Pedal
L : Clutch Pedal Free Travel
0000008471E
(3) Breather Plug
(A) 2WD Type
(B) 4WD Type
0000008230E
KiSC issued 04, 2006 A