Summary of Contents for Unfinished Furniture of Wilmington WC-19A
Page 1
ASSEMBLY INSTRUCTIONS Description SINGLE X ISLAND Item No. : WC-19A AND WC-19B ITEM NO.: WC-19A AND WC-19B Printed in Vietnam REVISED MAY 20, 2019 THIS ITEM IS PACKED IN TWO CARTONS - 1 -...
Protect the surface of the product with cloth if you are using any product with rubber feet or base. ASSEMBLY TOOLS REQUIRED NOT INCLUDED ITEM NO.: WC-19A AND WC-19B Printed in Vietnam REVISED MAY 20, 2019 THIS ITEM IS PACKED IN TWO CARTONS...
Page 3
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: Description Sketch Description Sketch (L-R) Stretcher X-frame Cross bar ITEM NO.: WC-19A AND WC-19B Printed in Vietnam REVISED MAY 20, 2019 THIS ITEM IS PACKED IN TWO CARTONS - 3 -...
Page 4
(Front) (Back) Apron Bottom (Center) Door Vertical panel Shelf Drawer front Drawer side Drawer back (L-R) Drawer bottom ITEM NO.: WC-19A AND WC-19B Printed in Vietnam REVISED MAY 20, 2019 THIS ITEM IS PACKED IN TWO CARTONS - 4 -...
(5.2/13 x (M4 x 30mm x 1.2mm) 110mm) (7 x 10mm) U-Washer NOTE: HARDWARE IS PACKED IN CARTON WC-19B. ITEM NO.: WC-19A AND WC-19B Printed in Vietnam REVISED MAY 20, 2019 THIS ITEM IS PACKED IN TWO CARTONS - 5 -...
Page 6
STEP 2 Attach x-frame (D) to the top (A) and crossbar (E) with bolts (2), and washers (7) and (6) as shown below. Tighten with Allen key (15). ITEM NO.: WC-19A AND WC-19B Printed in Vietnam REVISED MAY 20, 2019...
Page 7
Attach side frame (F) to stretcher (E) with bolts (3), and washers (7) and (6) as shown below. Tighten with Allen key (15). Insert the aprons (I), (J) and (H) into side frame (F) as shown below. ITEM NO.: WC-19A AND WC-19B Printed in Vietnam REVISED MAY 20, 2019...
Page 8
Attach aprons (H) and (I) to the top (A) with screws (9) as shown below. Tighten with a screwdriver. Slide vertical panel (M) into the grooves, as shown below. ITEM NO.: WC-19A AND WC-19B Printed in Vietnam REVISED MAY 20, 2019...
Page 9
Insert drawer bottom (R) into the grooves at bottom of drawer sides (P). Then attach drawer back (Q) to the drawer sides (P) with screws (10). Tighten with a screwdriver. ITEM NO.: WC-19A AND WC-19B Printed in Vietnam REVISED MAY 20, 2019...
Page 10
Insert brackets (12) into the unit as shown below. Place shelves (N) on the brackets and attach with screws (11). Tighten with a screwdriver. ITEM NO.: WC-19A AND WC-19B Printed in Vietnam REVISED MAY 20, 2019 THIS ITEM IS PACKED IN TWO CARTONS...