Table of Contents
Advertisement
To delete a start time:
1. Press
until START 1 appears.
2. Press
until the start time appears that you want to delete.
3. Press
until the word OFF appears.
Press the
button to proceed to the next step RUN TIME
the program.
11. SETTING WATERING RUN TIMES (DURATION)
This setting determines the length of time the 400A controller will allow the valve
to remain open (duration is from 1 minute up to 5 hours and 59 minutes). For
example, setting watering run time to 10 minutes on certain days of the week will
program the controller to turn the water on for 10 minutes on each of the days
chosen and at every start time selected. (Note: if the timer is set to water every X
hours, the maximum duration is 59 minutes)
To set the watering run time
:
1. Press the
button until the
setting appears. (OFF will appear if duration is set to 0)
2. Press the
button, and 0:00 (or the last run time programmed) appears with
hours flashing.
or to review
icon appears and OFF or the last run time
12
12
3. To set a desired watering run time in hours, press
number of hours.
4. If only watering duration in minutes is required, press
and the minutes will start flashing.
5. To set the desired watering duration in minutes (example of 10 minutes), press
or
to select minutes. When programming the watering duration, if you
are set to water on specific days of the week, the screen will also show the days
the timer will operate with an underline.
At this point the controller's normal programming is concluded.
Press the
button to proceed to the next step RAIN DELAY
the program or to exit.
or
and select the
to skip the hour digit,
or to review
13
Advertisement
Table of Contents
