Table of Contents
Advertisement
Option 4 – Setting every X days:
Example: setting the timer to water every 10 days:
1. Press the
button until the
2. Press
and
to skip all the days of the week (underscore must be
removed beneath all days).
3. Press
and EVEN appears flashing.
4. Press
again and 1 hour appears flashing.
5. Press
again and 1 DAY appears flashing. To select the number of days
between watering to 10 days, press
To set the timer back to specific days mode:
1. Push the
button until – START EVERY and the
left of the screen.
2. Push the
until the days of the week appear at the top of the screen.
Press the
button to proceed to the next step START TIME
the program.
icon and the days of the week appear.
until 10 appears on the display.
icon appear at the bottom
or to review
10
10
10. SETTING WATERING START TIMES
The 400A controller can have up to four separate irrigation start times per
day. (Note: if the timer is set to water every X hours, only one start time is available
to be programmed.)
To set a start time,
1. Press the
button until the
last start time programmed in START 1 appears.
2. Press
and OFF (or the first start time programmed) begins flashing.
3. To set the desired first start time hour (note AM and PM designations), press
or
.
4. Press
and the minutes start flashing.
5. Press
or
and set the desired start time minutes.
6. Press
again, the second start time and OFF or the last start time
programmed appear flashing. Repeat the steps to set the second, third, and
if needed,the fourth start time. During programming, if you are set to water
on specific days of the week, the screen also shows which days the timer will
operate with an underline.
icon appears. START 1, displays OFF or the
11
Advertisement
Table of Contents
