Threader Drawing Lever - Janome MC 11000 Service Manual

MC 11000
Adjusting Thread Drawing Lever
The standard height of the thread drawing lever from the surface of the bobbin holder
should be in the range of 5.45 - 5.75 mm.
(2)
VIEW - A
(1)
VIEW - X
5.45 - 5.75 mm
(3)
www.promelectroavtomat.ru
1. Remove the needle plate.
2. Loosen the hexagonal bolt (1) and adjust the distance
of the thread drawing lever (2) from the bobbin holder
(3) to be between 5.45 mm and 5.75 mm by moving
the thread drawing lever up or down.
3. Tighten the hexagonal bolt.
4. Attach the needle plate
5.5 mm
(Gauge 860G001)
40