To Adjust Thread Drawing Lever - Janome MC6600 Service Manual

TO ADJUST THREAD DRAWING LEVER

THE MAXIMUM HEIGHT OF THE THREAD DRAWING LEVER SHOULD BE BETWEEN 5.5 TO
5.7 MM.
THREAD DRAWING LEVER
VIEW A
HEXAGONAL SOCKET SCREW
5.5 TO 5.7 MM
BOBBIN HOLDER
HEXAGONAL
SOCKET SCREW
1 REMOVE THE NEEDLE PLATE.
2 LOOSEN THE HEXAGONAL SOCKET SCREW.
WHEN THE THREAD DRAWING LEVER IS AT THE
HIGHEST POSITION, ADJUST THE DRAWING
LEVER SO THE DISTANCE BETWEEN BOBBIN
HOLDER AND THE DRAWING LEVER IS 5.6 MM.
3 TIGHTEN THE HEXAGONAL SOCKET SCREW.
4 ATTACH THE NEEDLE PLATE.
VIEW A
(GAUGE 846-G01)
26
5.6 MM