MSI Wind Board 330 Manual page 22

Front Panel Connector: JFP1
This connector is for electrical connection to the front panel switches and LEDs. The
JFP1 is compliant with Intel
PIN
1
2
3
4
5
6
7
8
9
Chassis Intrusion Connector: JCI1
This connector connects to the chassis intrusion switch cable. If the chassis is
opened, the chassis intrusion mechanism will be activated. The system will record
this status and show a warning message on the screen. To clear the warning, you
must enter the BIOS utility and clear the record.
®
Front Panel I/O Connectivity Design Guide.
10 9
-
Power
Switch +
Power
LED
2
1
JFP1
JFP1 Pin Definition
SIGNAL DESCRIPTION
HD_LED + Hard disk LED pull-up
FP PWR/SLP MSG LED pull-up
HD_LED - Hard disk active LED
FP PWR/SLP MSG LED pull-up
RST_SW - Reset Switch low reference pull-down to GND
PWR_SW + Power Switch high reference pull-up
RST_SW + Reset Switch high reference pull-up
PWR_SW - Power Switch low reference pull-down to GND
RSVD_DNU Reserved. Do not use.
CINTRU 1
2
GND
JCI1
+
Reset
-
Switch
-
HDD
+
LED
En-13