2) Secure the SCSI Board with the 2 screws.
3) Install the scanner driver software in your
computer according to the enclosed manuals.
4.7. Connecting the Unit to a Personal Computer
Note:
* AC cord shown on the figure is for AC100-120V.
Caution :
Set the power switch on the scanner and on the personal computer to OFF before connecting the
interface cable.
Use only the power cord that is supplied by the manufacturer.
4.8. System Conditions Requirements
When using the scanner, the required personal computer conditions are as follows.
Pentium 166MHz or higher (Pentium, Celeron processor or higher is
CPU
recommended.
Memory
64 MB or higher (128 MB or higher is recommended.)
Windows 95/Windows 98/Windows NT/Windows2000/Windows Me
OS
SCSI board
Adaptec Brand AHA-1540/2930/2940/19160/29160 Series are
recommended.
* The scanning speed differs depending on the personal computer operating environment or
9