Insert the DIMM module into the connector on the
SCSI interface board at an angle [ Place ( 1 ) ]. Push
in the module as far as it goes. The levers should
lock automatically. If not, push the levers to lock the
module in [Place ( 2 ) ].
Note:
- Be sure that the DIMM module will be in the proper
position and the proper side.
- To remove the DIMM module, release the white
levers at both sides of the connector.
4.6. Installing the SCSI Board
1) Insert the SCSI Board into the unit along the rails
and push it in firmly.
Confirm that the SCSI board plate is fully inserted
until it firmly locks in place.
8