Hilti SCO 6-A22 Original Operating Instructions page 26

6.1.5 Installing the depth gauge
WARNING
Risk of injury! A damaged depth gauge may present a risk of inadvertent contact with the accessory tool.
▶ Do not use the power tool if the depth gauge is defective.
1. Hold the depth gauge in position on the product and tighten the securing screw.
2. Slacken the securing screw to adjust the depth gauge.
3. Slide the depth gauge to the desired position and re-tighten the securing screw.
4. Before starting, make sure that the space behind the workpiece is enough to keep the accessory tool
from contacting a hard object.
6.1.6 Installing the vacuum cleaner hose connector
1. Remove the accessory tool. → page 19
2. Install the hose connector on the product and set the connector to the desired position.
3. Engage the retaining lugs.
6.2 Types of work
ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function selection during operation.
Observe the safety instructions and warnings in this documentation and on the product.
6.2.1 Holding the product correctly
1. Use clamps or some other practical means to secure the workpiece and keep it in a stable position.
2. Use both hands to hold the product firmly when working.
▶ The product can become unstable if you attempt to hold it with only one hand or pressed against a
part of the body and this can result in loss of control.
6.2.2 Switching on 9
The on / off switch with safety lock (switch-on interlock) gives you full control of the switch function
and avoids unintentional starting.
1. Push the safety lock forward.
▶ The on/off switch is unlocked.
2. Press the on/off switch as far as it will go.
▶ The power tool's motor runs at no-load speed.
6.2.3 Switching off
▶ Release the on/off switch.
▶ The switch-on interlock jumps automatically into the locked position.
6.2.4 Operation
1. Hold the product firmly without the accessory tool contacting the working surface.
2. Switch on. → page 20
3. Guide the accessory tool straight into the material in which the cut-out is to be made, until the depth
gauge is in contact with the working surface.
4. Applying steady pressure, advance the accessory tool.
7 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
20 English
6
7
8
2194405
*2194405*