Table of Contents
Advertisement
Mounting the Router
Figure 5: Mounting Plate Details
Item
1
2
3
4
5
Install the Mounting Plate Poles Up To 4.5 Inches in Diameter
Required Materials
• Mounting plate, carriage bolts, and clamp brackets as described in
• 13-mm box-end socket wrench
To install the mounting plate on a vertical pole up to 4.5 inches (11.4 cm) in diameter, perform this procedure.
Step 1
Select a mounting location on the pole and place the top and bottom pole clamp bracket (1) notches against the pole.
Step 2
Place one of the clamp brackets on the opposite side of the pole, aligning the clamp bracket holes with the top two carriage
bolt holes on the mounting plate.
Step 3
Insert a carriage bolt (5) through each of the top two carriage bolt holes on the mounting plate and through the holes in
the clamp brackets.
Step 4
Position each bolt in the clamp so that the bolt is next to the pole, as shown in the following figure.
Description
Qty.
Carriage bolt holes
4
Bracket mount holes
8
Clearance holes, 3/4 in.
2
Pole clamp notches
2
Steel band strap slots
4
Install the Mounting Plate Poles Up To 4.5 Inches in Diameter
Pole Mount Kit, on page
Mounting the Router
2.
7
Advertisement
Table of Contents
