Table of Contents
Advertisement
Connect the unit to the network.
If you have a network environment,
you can connect the unit to the Internet
through a network cable or to a wireless
LAN using an Ethernet/wireless LAN
media converter. You can easily create a
wireless LAN connection by connecting
a BUFFALO USB wireless LAN adaptor
to a USB connecting jack on the unit.
For details, see "Network connection and
setup" on page 82.
With an Internet connection, you can
enjoy various Internet-based functions
(pages 19, 21, 55, 73 and 96).
Connect the power cord.
Connect the power cord to a wall outlet
after all other connections have been made.
The unit turns on automatically and starts
making the initial settings. Wait until the
unit turns off again.
The initial settings may take a few minutes
depending on the unit's condition.
WARNING
Do not disconnect the power cord while the
initial setup is in progress. Doing so may cause
the unit to malfunction.
To insert the batteries into the
remote control
Insert two size-AA (R6) batteries
(supplied) into the remote control with the
+ and – terminals matching the polarity
markings.
When the remote control is no longer able
to operate the unit, replace both batteries
with new ones.
To set up the AM loop antenna
1
Unroll the antenna cord from the antenna.
Antenna cord
2
Assemble the AM loop antenna so that it
stands vertically.
Unfold the stand, raise the antenna vertically,
and insert it into the slot as shown in the
figure below.
1
GB
Advertisement
Table of Contents
