Table of Contents
Advertisement
Transferring tracks to a "WALKMAN"
(ATRAC AD)
Notes
Make sure that you do not disconnect the USB
cable while transferring tracks to a "WALKMAN"
(ATRAC AD). If you do, the unit or the
"WALKMAN" (ATRAC AD) may malfunction.
With the procedures in this section, you may
not be able to transfer tracks in the case of some
"WALKMAN" models. In this case, select USB
storage device as the transfer destination. See
"Transferring tracks to a USB storage device" on
page 48 for details. Refer to the customer support
site of Sony Europe, http://support.sony-europe.
com/ (for the customers in Europe only) for
details on the compatible models and compatible
functions for each model.
If two "WALKMAN" (ATRAC AD) models are
connected to both jacks (rear and front) at the
same time, the device connected to the front jack
takes priority.
Quick mode
In this mode, tracks that were saved to
the HDD Jukebox after the last transfer
are automatically selected. Since the unit
recognizes each "WALKMAN" (ATRAC
AD) that was ever connected to it, the unit
has the transfer record of each one. Linear
PCM-format tracks are automatically
converted to MP3/128 kbps when
transferred.
Tip
If you want to convert Linear PCM tracks to a
format other than MP3/128 kbps, do the procedure
in "Standard mode" (page 48).
1
Connect the "WALKMAN" (ATRAC AD)
to a USB connecting jack on the unit.
Refer to the operating manual of the
"WALKMAN" (ATRAC AD) as well.
Front or rear of the unit
To the USB
connecting jack
USB connector
2
Enter the Function menu and select
[HDD JUKEBOX].
Make sure the TRANSFER button is set
to "WALKMAN" (ATRAC AD) (page
46).
3
Press TRANSFER on the remote
control or the main unit.
4
Make sure the groups that have not
been transferred are checked
Uncheck any group you do not want to
transfer.
Remaining space of the connected device
5
Select [Execute] or press TRANSFER.
To the USB
connecting jack
USB cable supplied
with the "WALKMAN"
(ATRAC AD)
"WALKMAN"
(ATRAC AD)
.
GB
Advertisement
Table of Contents
