Table of Contents
Advertisement
AXON Flex Controller
The controller enables you to turn the unit on, begin recording of an event, stop recording, and turn the unit off.
The controller features LEDs to indicate the operating mode and battery capacity.
NOTE: You can turn off the controller LEDs, if necessary. See Turning off the Controller LEDs for instructions.
Operation LED
Front View
1
Operation LED – Shows the controller's current operating mode:
Operation LED
Blinking Red
Blinking Green
Solid Red
Blinking Yellow
NOTE: For the battery status, see the Battery LED, described below.
2
On/Off Switch – Turns the controller on or off.
3
On/Off Indicator – When the controller is turned on, the red portion of the controller is exposed. When the
controller is turned off, the red portion is covered from view.
4
EVENT Button – A double-press (quickly press twice) on the EVENT button takes the Flex system into
EVENT mode and begins recording video and audio (the Flex system can be configured without the audio
recording capability for locations where audio recording is restricted).
A 3-second press of the EVENT button takes the Flex system out of EVENT mode. The controller might take
several additional seconds to close out of the event video when it is taken out of EVENT mode.
Top View
On/Off Switch
On/Off Indicator
Battery LED
EVENT Button
Battery Button
Operating Mode
Recording
Buffering
Booting Up
The Cable is Disconnected
6
Chapter 2
Hardware
Advertisement
Table of Contents
