Table of Contents
Advertisement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult TASER International Customer Service for help.
FCC/IC NOTICE: This device meets the body worn human exposure limits found in OET Bulletin 65, 2001, and
ANSI/IEEE C95.1, 1992. Proper operation of this equipment according to the instructions found in this guide
will result in exposure substantially below the FCC's recommended limits. To comply with the FCC and ANSI
C95.1 RF exposure limits, this device has been tested for compliance with FCC RF Exposure limits in the typical
configuration. The radiated output power of this wireless device is far below the FCC radio frequency exposure
limits.
RSS 210 Warning Statement: The installer of this equipment must ensure that the antenna is located or pointed
such that it does not emit RF field in excess of Health Canada limits for the general population; consult Safety
Code 6, obtainable from Heath Canada's Web site www.hc‐sc.gc.ca/rpb.
THIS MODEL DEVICE MEETS THE GOVERNMENT'S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Declaration of Conformity
TASER International declares that this AXON Flex system is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC.
A copy of the original eclaration of onformity can be found at www.TASER.com.
Chapter 11
Troubleshooting
50
Advertisement
Table of Contents
