Table of Contents
Advertisement
Care and Maintenance
Cleaning the AXON Flex System Components
Use a soft, damp cloth to clean the surface of the Flex system components. Do not use harsh cleaners or
solvents. Do not immerse the Flex system components in water or cleaning solutions.
If the Flex imager becomes dirty, use a lens blower brush to clean it and then wipe it with a soft cloth if necessary.
You may moisten the cloth with isopropyl alcohol.
Do not use Windex® or similar type cleaners on the camera lens.
Do not place the lens under running water or apply jets of water to the camera lens.
When the cable contacts show signs of contamination (e.g., with dirt or debris), clean them gently with a white
or red pencil eraser.
Charging the Flex Controller Battery
A fully charged Flex controller battery should provide enough power for approximately 12 hours of normal
operation. Recharging a battery after a 12-hour use can take up to 6 hours.
If the battery depletes significantly during the shift, you will hear 4 quick tones repeating every 20 seconds. This
message indicates that less than approximately 20 percent of the battery capacity remains.
Always recharge a depleted battery as soon as reasonably possible. You can use an ETM, wall charger, or
computer to charge the battery. Using a non-TASER approved wall charger may degrade device performance.
10
48
Advertisement
Table of Contents
