Table of Contents
Advertisement
Uploading Data and Recharging
AXON Flex Devices (Online)
The AXON Flex recorder and camera were designed for use with the AXON Flex Evidence Transfer Manager,
which recharges the devices' batteries and uploads data to the EVIDENCE.com website. See Using the ETM for
instructions on its use. If your department does not use the ETM, you can use your computer to perform these
functions; see Using Your Computer to Upload Videos.
When a camera is in Offline mode, the ETM will not upload or download videos from that camera. To download
videos in the Offline mode, see Chapter 9: Downloading Data in the Offline Mode.
Using the ETM
The ETM is factory configured to hold 6 cameras and 6 controllers. It must have a power supply and internet
access. Lights on the side of the ETM indicate proper connection. If you have difficulty using your ETM, check
to see if the connections are secure.
Flex Camera
Flex Controller
Power Supply
WAN (To Internet)
LAN (To PC)
1
Ensure the ETM is plugged into a power supply, is connected to the internet, and is powered on.
2
Dock the AXON Flex camera and controller in the ETM. The docking bays plug into the back of the camera
and the top of the controller.
NOTE: The camera must be assigned before docking in the ETM. See Assigning Your AXON Flex Equipment
for instructions on assigning your AXON Flex hardware to yourself. If the camera is not assigned before it is
inserted into the ETM then the videos will not upload.
43
8
Function Lights
Advertisement
Table of Contents
