Introduction; Functions And Use Of The Use And Maintenance Manual; Symbols And Qualification Of Operators; Declaration Of Conformity - CAMPAGNOLA POWER ECO Use And Maintenance Manual

1

INTRODUCTION

1.1

Functions and use of the Use and Maintenance Manual

Before working on the machine, carefully read and understand this Use & Maintenance Manual in order to safeguard the
operator and to avoid damaging the machine. These instructions describe how to operate the product safely, economically
and in compliance with the current safety regulations. Following these instructions helps avoid dangerous situations, re-
duces repair costs and downtime of the product and extends the life-span of the product itself. This manual must be intact
and legible in its entirety. Every operator involved in using the product or in charge of maintenance must know the location
and be able to read it whenever needed.
1.2

Symbols and qualification of operators

All human-machine operations herein described must be performed by personnel defined in compliance with the manufactur-
er's manual. Each procedure is accompanied by a pictogram which indicates the operator considered most suitable for the
tasks to be performed. The indication to identify the personnel qualifications are given below.
Personnel who can install, operate, adjust, clean, transport the machine and carry out its routine maintenance.
Mechanical personnel with specific skills, able to perform installation, extraordinary maintenance and/or repairs indi-
cated in this manual.
Electrical/electronic maintenance technician
Personnel with specific electric/electronic skills capable of performing installation, extraordinary maintenance and/or
repairs and of operating the product even when the safety and protective systems are partially or fully disabled. This
person is not qualified to perform mechanical interventions.
AUTHORISED WORKSHOP
The workshop authorised to carry out repairs on the Manufacturer's machines.
Precautions to be taken in order to safeguard the operators and bystanders in the work area.
Note to be taken in order to avoid problems with the product or to operate in compliance with the current
safety regulations.
1.3

Declaration of conformity

Every machine destined to countries included in the European Union (EU) is supplied with adequate characteristics to
the requirements of the Machinery Directive 2006/42/EC. Its manufacturer's Declaration of conformity is attached to
the Product.
1.4

Receiving the product

When receiving the product, make sure that:
• it has not been damaged during transportation;
• the supply matches the order (see "Product description" - chap. "Technical specifications").
If problems arise, please contact the manufacturer's Service Department quoting all details indicated on the rating
plate (refer to "Product Identification" - chap. "Technical specifications").
1.5

Warranty

Refer to the dedicated area on the Campagnola website for the general warranty conditions, at the following address:
http://www.campagnola.it; or send a written request on fax no. +39 051752551 or an e-mail to:
star@campagnola.it
For warranty claims, according to the above mentioned points, the product to be repaired must always be ac-
companied by the properly filled-in warranty card and the corresponding proof of purchase with date of pur-
chase (invoice or any other document with legal value).
Page 18
Use and Maintenance Manual – Translation of
Original Instructions Rev.: 03, Date 30/11/2021