Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Carbine 32cs
Summary of Contents for Carbine 32cs
- Page 1 O W N E R ’ S M A N U A L SECURITY SYSTEM with KEYLESS ENTRY...
-
Page 2: Congratulations
Congratulations Congratulations on the purchase of this CARBINE security system. Reading this owners guide prior to using the system will familiarize you with it’s many features. If issues arise or you have questions, contact your installing dealer first. Additionally, you can contact us... -
Page 3: Replacement Remote Controls
Replacement Remote Controls To purchase replacement remote controls, please see your authorized dealer/installer or visit us at www.carbine.com Remote part numbers are found on the back of the remote control. -
Page 4: Table Of Contents
Contents Congratulations ................2 Replacement Remote Controls ............3 4-Button Remote Configuration ............5 Using the System Arming/ Disarming ................ 6 Disarm without a Transmitter ............6 Panic Alarm ................... 7 Channel #3 and #4 Operation ............7 Valet Mode ..................8 Trigger the System ................. -
Page 5: 4-Button Remote Configuration
Remote Controls 4 Button Remote Configuration Button Function Action Arm/ Lock Press and Release Turn Off Panic Alarm Press and Release Disarm/ Unlock Press and Release Turn Off Panic Alarm Press and Release Activate Trunk Release Press and Hold for (CH#3) 2 Seconds Press and Release... -
Page 6: Arming/ Disarming
Note: If the system had previously been triggered, the tamper warning chirps will always sound upon disarm. Disarm without the Remote Control Your CARBINE system has an override mode that allows you to disarm your system in the event that you have lost or damaged your remote controller. -
Page 7: Panic Alarm
Panic Alarm 1. Press and hold the button for 3 seconds to activate panic alarm. Once activated, the panic alarm will sound the horn or siren and flash the parking lights for 30 seconds. 2. Press and release the button to stop the panic mode. -
Page 8: Valet Mode
Valet Mode (By Valet Button) Valet mode is a convenience when you take your car in for service or allow someone who may not be familiar with your security system drive your vehicle. - All doors must be closed - Turn the ignition key On then Off. - Press and release the valet button (1) time. -
Page 9: Trigger The System
Trigger the System If at any time the system becomes triggered, the horn/siren will sound for 30 seconds and then re-arm. If a protected entrance is left open, the alarm will sound for three, 30 second cycles and then the protected entrance is bypassed while the remaining detection zones are active. -
Page 10: Replacement Remote Pairing
Pairing a Replacement Remote Control Your CARBINE system remote controls are already paired to the control module. If you are replacing or adding remotes to your system, they must be programmed (paired) to the control module before they will operate the system. In order to perform remote control pairing, you must know where your “Valet Button is located... -
Page 11: Battery Replacement
Replacing the Remote Controller Battery The CARBINE remote controllers are powered by a CR2032 Lithium battery. When the battery begins to weaken, the operating range of the remote control is reduced and the LED indicator on the remote will begin to dim. - Page 12 © Copyright 2021 Magnadyne Corporation. All Rights Reserved. No part of this publication may be produced without the expressed written permission of Magnadyne Corporation. www.carbine.com | call 310-735-2000 | UM-32CS...
Need help?
Do you have a question about the 32cs and is the answer not in the manual?
Questions and answers