Table of Contents
Advertisement
Quick Links
PLUS4600UM
1/30/02
10:28 AM
Page 1
R
Vehicle Security
OWNER'S
MANUAL
Models: PLUS-4600
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user's authority to operate the equipment.
© Copyright 2002 Magnadyne Corporation
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Carbine PLUS PLUS-4600
Summary of Contents for Carbine PLUS PLUS-4600
- Page 1 PLUS4600UM 1/30/02 10:28 AM Page 1 Vehicle Security OWNER’S MANUAL Models: PLUS-4600 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
- Page 2 The information enclosed will provide a ready reference of the operation and maintenance of your new Carbine security system. Remote Control Transmitters Your Carbine security system operates from this transmitter shown here. use this drawing as a ready reference while reading through the operating procedures. Lock...
- Page 3 PLUS4600UM 1/30/02 10:28 AM Automatic Arming: (Without using the transmitter) Note: The following information is valid only if your security system has been programmed to automatically arm. 1. Turn off the ignition key and exit the vehicle. 2. Close all protected entrances. After the last protected entrance is closed the horn/siren will chirp one time and the LED indicator will begin to flash fast.
- Page 4 2. Place the valet switch to the “off” position. 3. Place the ignition key switch back to the “off” position. You will notice that the LED indicator will be off. This indicates that you have exited the valet mode and your Carbine Security System will operate normally.
- Page 5 Note: If a protected entrance is left open, your Carbine security system will remain triggered for two more 60 second cycles then fully re-arm excluding the door input trigger. (Door input trigger is no longer functional) Closing the entrance will re-set the door input trigger within 7 seconds.
- Page 6 30 seconds. Option #4: Single Zone Shock Sensor Installing option #4 will increase the level of security provided by your Carbine security system. If the shock sensor becomes activated the security system will immediately trigger your security system by sounding the horn/siren and flashing the parking lights.
- Page 7 Option #6: Dual Zone Shock Sensor Installing option #6 will increase the level of security provided by your Carbine security system. Zone #1 of the dual zone shock sensor will detect lighter non-threatening disturbances that would normally set off most sensors and trigger the security system.
- Page 8 10:28 AM System Maintenance: The only maintenance that your Carbine security system requires is a periodic check of it’s operation to be sure that all functions are operating properly. The batteries supplied with your transmitter will usually last about 1 year. Heavier usage will shorten battery life. Reduced transmitter range is usually a sign that the battery in the transmitter is becoming weak and should be replaced.
Need help?
Do you have a question about the PLUS PLUS-4600 and is the answer not in the manual?
Questions and answers