Carbine 32CS Quick Reference Install Manual

SECURITY SYSTEM with KEYLESS ENTRY
FOR PROFESSIONAL INSTALLATION ONLY!
If you are not proficient in the installation of this product or would like a full version
of the installation manual, please visit our web site @www.magnadyne.com
Valet Sw
LED
Note: Locate the vehicle START wire at the ignition switch.
Cut it and follow the instructions below.
To Vehicle Starter Wire
To Ignition Key Start Wire
Red: +12V Battery Power
Brown: (+) Siren
Black: Ground
White: Parking Light Relay Output
White: Parking Light Relay Power Input
Blue: (-) Negative Door Unlock Output
Green: (-) Negative Door Lock Output
Important Note: The main unit should be
securely anchored to a large wire loom or
stable surface for the shock sensor and the
tilt sensor to operate properly.
Pin Wire Color
1 Open
2 Green
3 Blue
4 Violet
5 Yellow
*Note: Low current outputs such as the 200mA, 300mA and 500mA (-) outputs on this unit
will only activate a relay (not supplied). They normally will not control any circuits in the vehicle
without installing a relay. Check your vehicle requirements before making any connections.
Starter Disable Wires
15A
10A
Function
None
(-) Door Pin Input
(-) Aux Hood/Trunk Input
(+) Door Pin Input
(+) Ignition Switch Input
Quick Reference Install Guide
10 9 8 7 6
5 4 3 2 1
Pin Wire Color
6 Black/White
7 Brown/Black
8 White/Blue
9 Red/White
10 Orange
10 PIN
(see chart)
Function
(-) 200mA Dome Light Control Output*
(-) 300mA Horn Output*
(-) 200mA Channel 4 Output*
(-) 200mA Channel 3 Output*
(-) 500mA Ground When Armed Output*