Gree 13-04685 Operating Instructions Manual page 11

11. Cut side channel seal into 2 equal
lengths. Remove the protective backing and
apply it to the rear side of the cabinet side
channels, starting just below the panel frame
assembly. Pinch off excess length so the seal
is even with the bottom of the cabinet side
channel.
12. To remove front
1. Remove the two front retaining screws
from the front frame.
2. Press firmly on each side of the metal
case close to the front, approximately
2/3 of the way down.
3. While pressing on the sides of the metal
case, gently pull the front out and lift up
to release it from the case.
4. Then remove the four screws from the
front frame to release the control panel
box.
NOTE: DO NOT push or pull air direction
louvers.
13. Place the air conditioner in the window
opening as shown to the right. It should sit
on the platform assembly so that the win-
dow panel frame, and the cabinet side chan-
nels are against the top and side window
jambs. Side channels should overlap side
window jambs equally.
14. Drill two 9/64-inch diameter pilot holes
in the top window jamb in line with the par-
tially plugged holes in the panel frame.
Secure the panel fame to the window jamb
with two #8-32x3/4-inch selfthreading
screws. If additional holding is necessary,
two screws may be used on the sides of the
panel frame as well.
15. Drill two screw-clearance holes in the
cabinet side channels (near bottom) and two
9/64-inch diameter pilot holes in the side
window jambs. Secure
the cabinet side channels to the window
jambs with two #8-32x3/4-inch self-thread-
ing screws. When doing this, be careful not
to twist the side channel seals with the
screws.
NOTE: Inserting screws will prevent the air
conditioner from being pushed into the
room.
Apply weather seal
to side channels just
below edge of panel
frame.
Screw
Front
retaining
screw
16. To replace the front
First reconnect the coupler plugs, make
the exhaust control positioned through the
front in the proper location. Gently push
the front into position on the cabinet. It
should click into place. Then replace the
retaining screws that holds the panel in
place.
Do not push or pull the front panel
louvers.
11