Table of Contents
Advertisement
- Be sure to unplug the power cord from the power outlet when
replacing the lamp.
- Because the lamp reaches a very high temperature during its
operation, wait until it cools completely when replacing the Lamp
Unit.
- The lamp emits small amounts of UV-radiation, avoid direct-eye
contact with the light.
- Because the high pressure lamp involves a risk of explosion, never
touch the lamp wire lead during the service. (See Fig. 3)
2. Operating Instructions
3. Self-Check Mode
This mode is used to narrow down the location of the failure.
3.1. Procedure to enter the self-check mode
While pressing the VOLUME "—" button on the remote control unit, press the left-arrow "
button on the main unit 3 seconds or longer.
3.2. Self-Check Display and Contents
MC-Service
Fig. 3
5
"
Advertisement
Table of Contents
